Hyper-V Server 2012 installation doesn't finish
i'm trying install hyper-v server 2012 on 1 of our servers. after first installation phase, server reboots , gives me "initializing devices" screen. after this, server reboots again , presents me screen stop error 0xc0000017, , won't let me boot os.
after fiddling, found out installing hyper-v server 2012 while server in uefi mode causes error. when install in bios mode, works fine. can't find stop error in combination hyper-v server on internet.
has encountered error before?
hi,
i found such error has record in kb 2209360, apply windows 7 , windows server 2008 r2.
in windows server 2012, before install windows on uefi-based computer, should note following:
- for platforms, may need perform additional steps make sure windows installed in uefi mode, , not in legacy bios-compatibility mode.
- uefi hard disks require guid partition table (gpt) partition structure, instead of master boot record (mbr) partition structure used in bios.
- windows preinstallation environment (windows pe) can configured support both uefi mode , bios-compatibility mode.
- note firmware manufacturers: not use tools or applications alter windows-specific boot files, including files in c:\boot , c:\efi folders. altering these files interfere computer’s ability boot up, resume hibernation, or run system recovery tools. instead, use tools such bcdboot set boot order.
for more information please refer following articles:
"c0000225" or "c0000017" error occurs when try start windows pe ram disk image on uefi-enabled computer running windows 7 or windows server 2008 r2
http://support.microsoft.com/kb/2209360
deploying windows uefi firmware overview
http://technet.microsoft.com/en-us/library/hh825095.aspx
extensible firmware interface (efi) , unified efi (uefi)
http://www.intel.com/content/www/us/en/architecture-and-technology/unified-extensible-firmware-interface/efi-homepage-general-technology.html
hope helps!
technet subscriber support
if technet subscription user , have feedback on our support quality, please send feedback here.
lawrence
technet community support
Windows Server > Hyper-V
Comments
Post a Comment